One-Way Access Spikes
The Blade Runner one way access control consist of either a 1,000mm or 500mm heavy duty steel modules & steel end caps.
Each module has independently retracting teeth, when a vehicle approaches from the correct direction the teeth simply retract allowing the vehicle to pass freely, when approached from an unauthorised direction the teeth lock up denying access and risking almost certain tyre damage.
Key features of the one way access spikes include high visibility lime green powder coat finish and an ultra low profile construction to ensure adequate vehicle clearance. The one way access control system has been designed to provide a soft approach for vehicles due to its low ramp angle and reduced height. These same features also eliminate much of the noise commonly associated with older style products.
Six fixing points per metre (4 per 500mm module), heavy steel construction, steel end caps and revolutionary new spring design ensure a long service life with low maintenance.
WARNING: - Always check with your local authority or controlling body to ensure one way access spikes are allowable in your situation (this is the end users responsibility). One way access spikes MUST always be installed with an awareness sign kit. One way access spikes should always be placed clear of intersections and curved roadways. Failure to heed these warnings will void all warranties.
Speed Hump Slo-Motion Compliance
Slo-Motion Compliance Speed Hump is manufactured from Linear Low Density Polyethylene (LLDPE). Lightweight and strong design has the ability to take heavy duty traffic from vehicles, trucks and buses.
Wheel Chock Aircraft – Small Pair
Wheel Chock Aircraft – Large Pair
Bike Rack Schoolies
Bike Rack – Style 4
A sturdy mild steel and hot dip galvanised bike rack designed to be wall mounted to accommodate 1 full size bicycle with the ability to lock one wheel and the frame for total security. The bike is suspended on plastic coated prongs to protect the rims from possible damage. Can be used indoors or out. While galvanised is the standard finish, powder coating is also available on request.
Bike Rail – Style 3
A sturdy bike rail manufactured from marine grade 316 stainless steel and designed to accommodate 2 full size bicycles with the ability to lock both wheels and the frame for total security. Available with fully welded base plates for surface mounting, or extended legs with starter bars for setting into a concrete footing. Can be used indoors or out.
Bike Rail – Style 2
Manufactured from marine grade 316 stainless steel this bike rail is capable of accomodating two full size bicycles. Used indoors or out, the rail has the ability to lock both wheels and the frame for total security. Welded base plates for surface mounting, or extended legs with starter bars for setting into a concrete footing are also available.
Galvanised Bike Rail – Below Ground 400mm
Injection Moulded Wheel Chock – Small
Wheel chock manufactured from injection moulded plastic stops cars, trailers and caravans from moving when parked. Suitable for business and personal use, these wheel chocks take up little storage room in your vehicle.
Rubber Dock Bumper
Dock bumpers have been manufactured from heavy duty recycled rubber and moulded into a high performance B shape design. They are ideal for installation onto loading bays or areas where mobile trolleys and hand trucks are in operation and are the suitable solution protection against impact damage.
Wheel Stop Rubber
Rubber wheel stops are a popular low cost alternative to concrete wheel stops. The one piece design is made from black recycled rubber and finished with hi-vis yellow panels. Fixings sold separately to allow installation into concrete or asphalt surfaces..